Hand Sprayer for Pre-pasted Wallpaper InstructionsUpdated 5 months ago

How to use the Hand Sprayer for Pre-pasted Wallpaper:

1. Fill wallpaper sprayer with water. Pump handle to create pressure.

2. Cut wallpaper strip to fit wall height, allowing a few extra inches for trimming.

3. Lay cut strip, pattern side down, on floor or table, covered with a drop-cloth or towel to protect against any over spray of water.

4. Using the wallpaper spray bottle, activate the paste with a fine mist of clean water to entire back of the pre-pasted surface, paying close attention to the edges.

5. Fold top and bottom of strip toward center, paste to paste, allowing folded strip to sit for approximately three minutes, to relax paper & fully activate paste. (This is called booking.)

6. Take moistened strip to the wall and smooth into place with a smoothing brush or sponge.

7. Repeat procedure for each subsequent strip, trimming excess wallpaper from doors and windows with razor knife, and wiping excess paste from the front of each strip with a sponge and clean water.